Click the Exhibit button.

In the exhibit, all routers within each AS are configured for Anycast RP. All intra-AS routers are configured within the same MSDP mesh group. Inter-AS multicast has been enabled using MSDP without MSDP mesh groups. Which statement is true?

A. The AS border routers allow TCP port 636 in their infrastructure ACLs.

B. Duplicate SA messages may be received in AS2.

C. SA messages from R5, R7, or R8 are not forwarded to AS1.

D. Inter-AS MSDP peerings must be configured on the AS border routers.

Click the Exhibit button.

A network administrator has configured the LSPs shown in the exhibit on the ingress router of a 10-Gigabit Ethernet network Which statement is true?

A. Both LSPs will establish and remain established.

B. The Boston-to-Denver LSP will establish and remain established.

C. The Boston-to-Seattle LSP will establish and remain established.

D. Neither LSP will remain established.

You have recently deployed PIM-SM in your network and must control some of the associated protocol exchanges.

Which three statements are true? (Choose three.)

A. Policy can be used to control outgoing register messages at the source RP.

B. Policy can be used to control outgoing register messages at the source DR.

C. Policy can be used to control incoming register messages at the RP.

D. Policy can be used to control incoming register messages at the DR.

E. Policy can be used to control incoming and outgoing join and prune messages.

You are setting up MPLS RSVP LSPs between R1 and R6 through your core network. You must ensure that R1 has redundant ERO paths. If the main path fails and moves traffic to a second path, it should not switch back to the original path automatically. Which two actions will accomplish these requirements? (Choose two.)

A. Create two secondary paths.

B. Create a primary path with a revert timer of 0 and create a secondary path.

C. Create two primary paths.

D. Create a primary path with the revert timer set to 255 and create a secondary path.

-- Exhibit -- Exhibit -Click the Exhibit button. Referring to the exhibit, which two configuration steps must be implemented so that LSPs will be able to

use link protection from R1 to R3? (Choose two.)

A. Configure each eligible interface for link protection.

B. Configure each eligible router's protocol RSVP for fast reroute.

C. Configure each eligible router's protocol MPLS for link protection.

D. Configure each eligible LSP for link protection.