In which two ways can users and endpoints be classified for TrustSec? (Choose Two.)

A. VLAN

B. SXP

C. dynamic

D. QoS

E. SGACL

A network engineer is configuring guest access and notices that when a guest user registers a second device for access, the first device loses access What must be done to ensure that both devices for a particular user are able to access the guest network simultaneously?

A. Configure the sponsor group to increase the number of logins.

B. Use a custom portal to increase the number of logins

C. Modify the guest type to increase the number of maximum devices

D. Create an Adaptive Network Control policy to increase the number of devices

An organization is adding new profiling probes to the system to improve profiling on Oseo ISE The probes must support a common network management protocol to receive information about the endpoints and the ports to which they are connected

What must be configured on the network device to accomplish this goal?

A. ARP

B. SNMP

C. WCCP

D. ICMP

An engineer is configuring Cisco ISE policies to support MAB for devices that do not have 802.1X capabilities. The engineer is configuring new endpoint identity groups as conditions to be used in the AuthZ policies, but noticed that the endpoints are not hitting the correct policies.

What must be done in order to get the devices into the right policies?

A. Manually add the MAC addresses of the devices to endpoint ID groups in the context visibility database.

B. Create an AuthZ policy to identify Unknown devices and provide partial network access prior to profiling.

C. Add an identity policy to dynamically add the IP address of the devices to their endpoint identity groups.

D. Identify the non 802.1x supported device types and create custom profiles for them to profile into.

An engineer is configuring the remote access VPN to use Cisco ISE for AAA and needs to conduct posture checks on the connecting endpoints After the endpoint connects, it receives its initial authorization result and continues onto the compliance scan

What must be done for this AAA configuration to allow compliant access to the network?

A. Configure the posture authorization so it defaults to unknown status

B. Fix the CoA port number

C. Ensure that authorization only mode is not enabled

D. Enable dynamic authorization within the AAA server group