You notice a mass withdrawal of routes for some of the network hosts. You determine that the link on the ESI interface is down.

Which route type is used in this scenario?

A. Type 2

B. Type 3

C. Type 1

D. Type 5

You have an MX960 configured as a Fusion aggregation device (AD) and two QFX5100 switches as satellite devices (SD). You have configured local-switchingfor each SD. A packet with an unknown MAC address is received on one of the SD extended ports.

Which statement is correct in this scenario?

A. The packet is dropped and a reject message is sent out to the port where it was received.

B. The packet is silently discarded and a reject message is sent to the AD.

C. The packet is flooded out of all the ports on the SD except the one where it was received.

D. The packet is sent to the AD to be processed and forwarded.

When configuring class of service, what would you use to allocate bandwidth to a forwarding class?

A. buffer depth

B. transmit rate

C. bandwidth

D. speed

Click the Exhibit button.

During an outage, you review the status of the Q-in-Q implementation on VLAN 300. Referring to the exhibit, what would be the cause of the outage?

A. The S-VLAN is disabled.

B. The VLAN range overlaps.

C. The C-VLANs are disabled.

D. There are no active ports.

Click the Exhibit button.

You are implementing CoS for a custom application that is labeling its packets with DSCP code-point 101111. You have applied the configuration shown in the exhibit, but note that while some custom application traffic ingressing on ge-0/0/1 transits the SRX Series device successfully, packets ingressing all other ge-* interfaces are being dropped.

Which action should you take to solve this problem?

A. Apply the rate-limit-efpolicer to all ge- interfaces.

B. Remove the BA classifier from all ge- interfaces.

C. Configure a scheduler and scheduler map for expedited-forwarding and apply to all interfaces.

D. Modify the BA classifier to assign code point 101111 to loss priority low.