You have created volumes using array management tools and imported the volumes to HPE OneView.

Which statement about these volumes is true?

A. Imported volumes are treated as private volumes and can be only used as boot volumes

B. Volumes imported to HPE OneView is managed just like a volume created using HPE OneView

C. Volumes imported to HPE OneView cannot be removed using the HPE OneView interface

D. A snapshot for imported volumes can be created only by using array management tools

A customer has to deploy 21 HPE Synergy Compute Modules in a boot from SAN setup. How this task can be simplified while keeping the profile consistent?

A. Boot volumes can be created on demand and defined in the server profile template

B. An existing volume can be replicated automatically when creating a server profile

C. A single SAN volume can be created and utilized by all E Synergy Compute Modules

D. Boot volumes can be prepared in advance and later presented as shared volumes to the Compute Modules

You try to add an HPE Primera array to HPE OneView, but you get a connectivity error. However, you can connect to the array using SSMC. What should you verify before adding HPE Primera to HPE OneView?

A. whether WSAPI service is enabled on HPE Primera array.

B. whether the appropriate license for HPE Primera Is available in HPE OneView.

C. whether array management using HPE OneView is enabled in SSMC.

D. whether there are at least two Fibre Channel networks defined in HPE OneView.

Which statement about a Logical Enclosure for HPE BladeSystem is Hue?

A. A logical enclosure can have between 1 to 5 HPE BladeSystem c7000 enclosures.

B. A logical enclosure must be created only for monitored HPE BladeSystem C700O enclosures.

C. A logical enclosure is created automatically, and it is always based on a single enclosure.

D. A logical enclosure can contain a mix of HPE BladeSystem c7000 and C3000 enclosures.

You configured downlink aggregation for one of the HPE Synergy Compute Modules in an environment by placing two connections in the same Link Aggregation Group. After you made the changes to the server profile, its status changed to critical.

What can be done to fix this issue?

A. The teaming or bonding driver in the server OS must be configured to enable the LACP and to form the LAG correctly.

B. The server profile for a given HPE Synergy compute module should be reapplied, then the Compute Module should be rebooted.

C. Link Aggregation Group functionality should be enabled in advanced properties of the Logical Interconnect.

D. Ensure that the Link Aggregation Group time-out value matches the server set values.