After performing a NIM rte install, the administrator noticed that not all filesets are at the correct Technology Level (TL). What action will help the administrator determine why the inconsistent fileset levels were installed?

A. On the NIM server, run an Ippchk to identify if the Software Vital Product Data is valid.

B. On the NIM client, run oslevel command against the TL to identifymissing prerequisites.

C. Run instfix command on NIM client to determine what filesets are inconsistent.

D. On the NIM server run the NIM IsIpp command to indentify downlevel filesets contained in the lpp_source.

The AIX hosts node1 and node2 have Ethernet adapters, both named ent0, configured on the same network. Both are dedicated physical 1GB adapter ports in a Host Ethernet Adapter. Based on this information and the output shown for each node, what is the most likely cause of intermittent failures and slow communication between these adapters?

A. The jumbo_frarnes setting is 'no' and should be set to 'yes'.

B. The Multi-Core Scaling mode is enabled. Multi-Core Scaling is interfering with communications because the processor is too busy.

C. The Shared Ethernet Adapter does not have enough bandwidth to accommodate the network traffic.

D. The media speed is set differently on the adapters than the endpoints on the switch.

In the following figure, what TWO things must be done before an EtherChannel can be created from the ent0 and ent1 adapters?

A. The ent0 and ent1 adapters must be connected to different switches to provide both additional bandwidth and adequate redundancy in the EtherChannel that is created.

B. EtherChannel support capability must be verified for the Ethernet switch.

C. The IP configuration must be removed from en0.

D. The AIX host must be completely disconnected from the network,

E. The en1 interface must be configured with IP information.

Which command will show the status of Geographically Mirrored Volume Groups?

A. gmvgstat

B. geovgstat

C. Isglvm

D. listgm

Which command can an administrator use to discover the port VLAN for ent3?

A. entstat –d ent3

B. lsvlan –l ent3

C. ifconfig ent3

D. netstat –ad