An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

1.

This information was gathered during a workshop:

2.

Some workloads should be moved to a Cloud Provider.

3.

Extend network's VLAN or VNI across sites on the same broadcast domain.

4.

Enable VM mobility use cases such as migration and disaster recovery without IP address changes.

5.

Support 1500 byte MTU between sites.

Which should the architect include in their design?

A. SSL VPN

B. Reflexive NAT

C. L2 VPN

D. Load Balancer

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during a workshop about ESXi Host networking:

1.

A total of 50 ESXI hosts to be configured as Transport Nodes.

2.

All ESXi hosts have a dedicated 2 x Intel 10Gbps Physical Network adapter for the Overlay Traffic.

To achieve low latency, high throughput, redundancy, and performance, which two NIC teaming policies should the architect recommend? (Choose two.)

A. Load Balance Port ID

B. Load Balance Source

C. Load Balance Source Port ID

D. Failover Order

E. Load Balance Source MAC

Refer to Exhibit:

An NSX-T architect has been asked to review and recommend improvements for an NSX-T Data Center Logical Design, as shown in the drawing. The design must allow workload bursts for tenants to and from the public cloud and accommodate 30% yearly growth.

What two VMware recommended changes will Improve the Logical design? (Choose two.)

A. A separate POD is required for the NSX Edge nodes since the amount of traffic will be heavy.

B. An additional POD will be required to pivot workloads to Public Cloud.

C. Automation tools will be required to reduce time for workloads to be vMotioned.

D. Load balancers should be added to the design to support bursts from the Public Cloud.

E. NSX-T Datacenter components needs to be placed on the Public Cloud for cost reduction.

An architect is helping an organization design an NSX-T Data Center solution. This information was gathered during a workshop:

1.

There are three LUNs In the storage array.

2.

There is no additional budget to purchase any more hardware.

3.

LUN 1 usage is 90% and is configured with a high-performance profile.

4.

LUN 2 usage is 75% and is configured with a high availability profile.

5.

LUN 3 usage is 60% and is configured with a balanced performance/availability profile.

6.

A highly available NSX Management cluster is required.

7.

ECMP routing is required.

Which should the architect recommend for the organization's NSX-T Datacenter environment?

A. Place all three NSX Managers on LUN 2 for high availability.

B. Place all three NSX Managers on LUN 1 to avoid latency.

C. Spread the NSX Managers across LUN 2 and LUN 3.

D. Spread the NSX Managers across the three LUNs.

An architect is designing a solution for containerization. The solution will include high availability and

security using NSX-T Data Center. The architect plans to provide a basic required components list In the

Logical Design.

Which solution should the architect recommend?

A. 2 NSX Managers, 2 virtual NSX Edges, one Tier-0 gateway, BGP configuration and a static route

B. 3 NSX Managers, 1 virtual NSX Edge, one Tier-0 gateway and a static route and OSPF

C. 1 NSX Manager, 2 virtual NSX Edges, two Tier-0 gateways In Active/Active, BGP configuration

D. 3 NSX Managers, 2 virtual NSX Edges, two Tier-0 gateways in Active/Passive, BGP configuration