An LTM device needs an additional traffic group. Which configuration item is required?

A. Default device

B. Group name

C. MAC Masquerade Address

D. Auto Fallback Timeout

An SSL application is being migrated to the LTM device. Both encrypted and unencrypted traffic are accepted by the server. The virtual server configuration is as follows:

Which LTM device profile should be used on the LTM device to reduce the CPU load on the current.

A. Protocol

B. serverssl

C. clientsssl

D. stream

TWO LTM devices are in the same Device Group and configured for Ac live/Standby Failover. The LTM Specialist observes that the HA Active and Standby device constantly changes state. All network links use the default route domain A dedicated fiber ink is used for the HA connection with a latency of 250 ms but no packet loss. What is causing the change in failover state to occur?

A. The HA network is using the default routing domain.

B. The HA network is using multicast IP.

C. The HA network is not configured for mirroring.

D. The HA network latency is too high.

An LTM Specialist plans to enable connection mirroring for a virtual server in an HA environment. What must the LTM Specialist consider before implementing the configuration change?

A. Impact on system performance that might be noticeable

B. The add-on license that is required for this feature to be available

C. Creating the required separate interface for connection mirroring

D. Decreased number of possible concurrent connections to that virtual server

An TLM Specialist has an Exchange that must use the LTM device to route traffic to the internet. Which SNAT/NAT configure allows the Exchange server's traffic access the internet through the LTM device?

A. NAT

B. SNAT Pool

C. SNAT List

D. SNAT Automap