HOTSPOT

A network administrator wants to receive a major alarm every time a controller or an Aruba switch goes down for either a local or an upstream device failure. Which alarm definition must the network administrator create to accomplish this?

Hot Area:

Refer to the exhibits. Exhibit 1

Exhibit 2

Exhibit 3

A network administrator wants to allow contractors to access the corporate WLAN named EmployeesNet with the contractor role in VLAN 40. When users connect, they do not seem to get an IP address. After some verification checks, the network administrator confirms the DHCP server (10.254.1.21) is reachable from the Mobility Controller (MC) and obtains the outputs shown in the exhibits.

What should the network administrator do next to troubleshoot this problem?

A. Permit UDP67 to the contractor role.

B. Remove the IP address in VLAN 40.

C. Configure the DHCP helper address.

D. Confirm there is an IP pool for VLAN 40.

An Aruba Mobility Master (MM) - Mobility Controller (MC) solution is connected to a wired network that is ready to prioritize DSCP marked traffic. A group of WMM-enabled clients sends traffic marked at L2 only.

What must the network administrator do to map those markings to DSCP equivalent values when traffic is received by the APs?

A. Enable WMM in the SSID profile.

B. Enable WMM in the VAP profile.

C. Enable Skype4Business ALG Support.

D. Enable traffic to be marked with session ACLs.

An Aruba WiFi solution for a football stadium includes 2500 APs, two Mobility Masters (MM), and eight Mobility Controllers (MCs). Key requirements are seamless roaming and even distribution of APs and clients, even during a MC failure. Which MC's deployment option offers seamless roaming, and even AP client distribution among all MCs before and after a MC failure?

A. a two-member HA group in dual mode

B. an eight-member L2-connected cluster

C. two four-member L2-connected clusters

D. an eight-member HA group in dual mode

Refer to the exhibit.

A network administrator completes the initial configuration dialog of the Mobility Controllers (MCs) and they join the Mobility Master (MM) for the first time. After the MM-MC association process, network administrator only creates AP groups, VAPs, and roles. Next, the network administrator proceeds with the configuration of the policies and creates the policy shown in the exhibit.

Which additional steps must be done to make sure this configuration takes effect over the contractor users?

A. Apply the policy in the contractors user role. Enable deep packet inspection. Reload the MCs.

B. Enable firewall visibility. Enable web-content classification. Reload the MCs.

C. Apply the policy in the contractors user role. Enable deep packet inspection.

D. Enable firewall visibility. Enable web-content classification. Reload the MMs.