Table of Acronyms

Refer to the exhibit

An administrator wants to connect four data centers using HP EVI. What is the correct setup for the EVI tunnel interfaces?

A. Three EVI tunnel interfaces on each EVI edge device-one EVI tunnel interface is required for each GRE tunnel in the mesh

B. One EVI tunnel interface on Switch 1, which will be configured as the ENDP server, and no interfaces on the other switches

C. Three EVI tunnel interfaces on Switch 1, which will act as the hub. and one EVI tunnel interface each on the other switches

D. One EVI tunnel interface on each EVI edge device--the devices automatically establish GRE tunnels between these interfaces

An administrator plans to deploy a wireless network, which might need to support a mix of 802.11g and 802.11n clients in the 2.4 GHz frequency. The administrator wants to prioritize transmissions for 802.11 n clients. Which 2.4 GHz radio setting helps to prevent slow clients from taking more than their share of transmission time?

A. Set up the channel reuse option.

B. Set up the fair scheduling option.

C. Set the mandatory data rate for 802.11g as low as possible.

D. Set the multicast data rate for 802.11n as low as possible.

An SDN application needs to create reactive flow table entries in response to specific packets. The flow_mod APIs will create the actual entries, but application must be configured with another API as part of this function.

What is that API?

A. A sequence packet listener (SPL) API that specifies the Director role and the match criteria for the packets

B. A listener API that registers the application to listen for data paths

C. A listener API that registers the application to listen for meters

D. A sequence packet listener (SPL) API that specifies the Advisor role and the match criteria for the packets

Table of Acronyms

Refer to the exhibit.

The switches shown in the exhibit form a TRILL region. What helps to load balance traffic across the .inks between these switches?

A. The TRILL cost for each link is the same, and TRILL Equal Cost Multi-Path (ECMP) is enabled.

B. VLANs 10, 20, and 30 are mapped to different spanning tree instances.

C. The switch-to-switch links are configured to permit at least two VLANs.

D. Switch 4 and Switch 5 are assigned the same Designated RBridge (DRB) priority.

A Company has APs that are deployed relatively close together. These APs are controlled by an HP Unified Wired-Wireless controller. Which setting helps to prevent the APs from interfering with each other while also letting the APs extend their coverage area if one of the AP fails?

A. Channel reuse

B. Dynamic frequency selection (DFS)

C. Transmit power control (TPC)

D. Fair scheduling