What are the Protocol Data Units (PDUs) called at the Transport layer?

A. Data Payload

B. Frame

C. Segment

D. Packets

Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?

A. Switch

B. Transceiver

C. NIC

D. Port

A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of them on different subnets. In addition, routing has been enabled on the switch.

Which action occurs when the switch receives a packet on one of its SVIs but the destination IP address of the packet does not match the IP address of that SVI?

A. Switch checks its routing table and forwards the packet accordingly.

B. Switch duplicates the packet and sends it to all interfaces.

C. Switch replies back to the source with an ICMP Reject packet.

D. Switch drops the packet.

Which Border Gateway Protocol (BGP) version supports IPv6?

A. BGPng

B. BGPv2

C. BGPv3

D. BGPv4

What accurately describes the comparison between stacking and VLT?

A. VLT allows for more physical devices to appear as one virtual device than stacking does.

B. Stacked switches share a common control plane while VLT peers maintain their own control plane.

C. Stacked switches and VLT peers allow "single pane of glass" management by maintaining a single control plane.

D. Both VLT and stacking allow devices to use different versions of firmware provided that the switch family/series is the same.