A technician has completed the configuration and programming for an implementation of a new Avaya CallPilot system. When the Avaya CallPilot is rebooted, over which local Area Network (LAN) connection does the Communication Server 1000 communicate with the Avaya CallPilot voicemail system?

A. DSO

B. CLAN

C. ELAN

D. SLAN

E. TLAN

A technician is installing an Avaya CallPilot with the NTRH40CA MBP96 CAT5 board and two NTRB18DA Mgate cards. When cabling the NTRB18DA Mgate cards in a Communication Server 1000S Media Gateway, which statement describes the cabling configuration that is the most valid?

A. Attach the customersupplied RJ-45cables to thefaceof the Mgate cards and then to the MBP96 card.

B. Attach the customer supplied RJ-45 cables to the backplane of the Media Gateway or MediaGateway expansion cabinet and then to the MBP96 card.

C. AttachNTDU0609 cables to the face of the Mgate cards and route them outside the Media Gateway. Then couple the customer supplied RJ-45 cables from the NTDU0609 to the MPB96 cards.

D. Attach the NTDU0609 cables to the face of the Mgate cards and take them outside the Media ay lo a customer supplied Ethernet hub. Attach RJ-45 cable from the hub to the MPB96cards.

Which two Avaya CallPilot Manager configurations are valid? (Choose two.)

A. Avaya CallPilot Manager installed on the Avaya CallPilot server

B. Avaya CallPilot Manager installed on the administrator's PC

C. Avaya CallPilot Manager installed on a standalone Web server

D. Avaya CallPilot Manager installed on the Avaya CallPilotserver with Reporter

A customer makes a call from their mobile telephone to Ext A on a PBX. Ext A is call-forwarded to Ext B. There is nobody to answer the call at Ext B, so the call is transferred to the Avaya CallPilot voicemail system. How will Avaya CallPilot treat the message?

A. the message will be storedin the mailbox for Ext A

B. the message will be storedin the mailbox forExtB

C. themessage will be stored in thegeneraldelivery mailbox

D. the message will be transferredto the operator

When installing an Avaya CallPilot RIs. 5.0 system using a 600r server and a Communication Server (CS) 1000 system, the customer has decided not to leave the Tandberg SLR 75 external tape drive connected to the SCSI connector on the rear panel of the server. Which action must be taken to ensure successful installation and operation of the Avaya CallPilot server in this configuration?

A. Ensure that the SCSItape drive terminator is connected to the back of the SCSI tape drive.

B. Ensure thatthe SCSI ID push button switch, located on the back of the tape drive, is set to 6.

C. Ensure that the Very High Density Connection Interface (VHDCI) Ultra320 SCSIterminatoris attached tothe SCSI port on the rear panel of the server.

D. Ensure that the power connectionfor the Tandberg SLR 75 external tape drive is connected to the single pointground point asthe Avaya CallPilot server and the CS 1000 system.