An engineer currently has a Cisco FTD device registered to the Cisco FMC and is assigned the address of 10.10.50.12. The organization is upgrading the addressing schemes and there is a requirement to convert the addresses to a format

that provides an adequate amount of addresses on the network.

What should the engineer do to ensure that the new addressing takes effect and can be used for the Cisco FTD to Cisco FMC connection?

A. Delete and register the device to Cisco FMC.

B. Update the IP addresses from IPV4 to IPV6 without deleting the device from cisco FMC.

C. Format and register the device to Cisco FMC.

D. Cisco FMC does not support devices that use IPv4 IP addresses.

A network administrator is configuring a Cisco AMP public cloud instance and wants to capture infections and polymorphic variants of a threat to help detect families of malware. Which detection engine meets this requirement?

A. RBAC

B. Tetra

C. Ethos

D. Spero

A Cisco FMC administrator wants to configure fastpathing of trusted network traffic to increase performance. In which type of policy would the administrator configure this feature?

A. Network Analysis policy

B. Identity policy

C. Prefilter policy

D. Intrusion policy

An organization is using a Cisco FTD and Cisco ISE to perform identity-based access controls. A network administrator is analyzing the Cisco FTD events and notices that unknown user traffic is being allowed through the firewall. How should this be addressed to block the traffic while allowing legitimate user traffic?

A. Modify lhe Cisco ISE authorization policy to deny this access to the user.

B. Modify Cisco ISE to send only legitimate usernames to the Cisco FTD.

C. Add the unknown user in the Access Control Policy in Cisco FTD.

D. Add the unknown user in the Malware and File Policy in Cisco FTD.

An organization has a compliance requirement to protect servers from clients, however, the clients and servers all reside on the same Layer 3 network. Without readdressing IP subnets for clients or servers, how is segmentation achieved?

A. Change the IP addresses of the servers, while remaining on the same subnet.

B. Deploy a firewall in routed mode between the clients and servers.

C. Change the IP addresses of the clients, while remaining on the same subnet.

D. Deploy a firewall in transparent mode between the clients and servers.