DRAG DROP

Drag and drop the EVPN components from the left onto the correct planes on the right.

Select and Place:

You try to configure MPLS VPN VRF Selection based on a source IP address on an interface that has VRF configured, but you receive an error. Which action must you take to correct the problem?

A. Change the source IP address.

B. Add the IP address to the VRF table.

C. Remove the VRF from the interface.

D. Configure static routes for the VRF.

Refer to the exhibit. Which result occurs when PE1 learns a new MAC address and all three PEs are enabled with EVPN native?

A. A system notification is sent to the network administrator that triggers the manual configuration of the new MAC address on PE2 and PE3.

B. The new MAC address is sent by BGP to PE2 and PE3 as a Type 2 BGP route.

C. The MAC address is entered into the CAM table and is classified for use on the native VLAN

D. The MAC address is entered into the CAM table only if it is learned on the native VLAN.

Refer to the exhibit. Which effect of this configuration is true?

A. It configures VPWS multihomed.

B. It configures VPWS single homed.

C. It configures an IPv4 peering with 192.168.1.1

D. It configures MPLS traffic engineering.

Refer to the exhibit.

Router 1 is a route reflector client within a service provider core PE1 cannot see VPNv4 routes received from the ASBR PE1 only has an iBGP relationship with Router 1. Which action resolves this issue?

A. Activate PE1 as a neighbor under the IPv4 address family.

B. Configure Router 1 as a route reflector for PE1 under the VPNv4 address family.

C. Configure PE1 to have an eBGP relationship with Router 1.

D. Enable BGP default ipv4-unicast