Scenario: The primary content switching vServer has gone down. To troubleshoot, a Citrix Administrator has issued the following command: > show csvserver CSV CSV (10.1.100.100:443) ?HTTPS Type: CONTENT State: UP Last state change was at Mon Jun 29 15:20:43 2020 Time since last state change: 1 day, 06:47:58 610 Client Idle Timeout: 180 sec Down state flush: ENABLED Disable Primary vServer On Down: DISABLED Appflow logging: ENABLED Port Rewrite: DISABLED State Update: DISABLED Default: Content Precedence: URL vServer IP and Port insertion: OFF Persistence: NONE redirect: http://www.site1.com/mysite1/maintenance Backup: vServer-LB-2 Listen Policy: NONE IcmpResponse: PASSIVE RHIstate: PASSIVE Traffic Domain: 0 Based on this output, where will the subsequent request be redirected?

A. http://www.site1.com/mysite1/maintenance

B. vServer-LB-2

C. Backup content switching vServer

D. 10.1.100.100:443

Scenario: A Citrix Administrator configures an Access Control List (ACL) to block traffic from the IP address 10.102.29.5:

add simpleacl rule1 DENY -srcIP 10.102 29.5

A week later the administrator discovers that the ACL is no longer present on the Citrix ADC.

What could be the reason for this?

A. The administrator did NOT run the apply ACL command.

B. The simple ACLs remain active for only 600 seconds.

C. The simple ACLs remain active for only 60 seconds.

D. The Citrix ADC has been restarted without saving the configurations.

Scenario: A Citrix Administrator configured a responder policy as follows:

> add responder action Redirect_Act respondwith"DIAMETER.NEW_REDIRECT(\"aaa://host.example.com\")"

> add responder policy Redirect_Pol "diameter.req.avp(264).value.eq(\"host1.example.net\")" Redirect_Act

> bind lb vServer vs1 -policyName Redirect_Pol -priority 10 -type REQUEST

What will be the effect of this configuration?

A. Request originated from "host1.example.net" will be redirected to "host.example.com".

B. Response originated from "host1.example.net" will be redirected to "host.example.com".

C. Response originated from "host.example.net" will be redirected to "host1.example.com".

D. Request originated from "host.example.net" will be redirected to "host1.example.com".

Scenario: Users are trying to access https://cs.mycompany.com, but are receiving the error below:

HTTP 503 Service Unavailable

What can a Citrix Administrator change in the Citrix ADC configuration to fix this?

A. Enable the content switching feature.

B. Disable the spillover redirect URL.

C. Bind a certificate.

D. Bind the default load-balancing vServer.

How can a Citrix Administrator configure a rewrite policy to change the version of HTTP from 1.1 to 1.0 in every request?

A. >add rewrite action RW_ACT replace http.res.version "\"HTTPS/1.0\"" > add rewrite policy RW_POL true RW_ACT

B. >add rewrite action RW_ACT replace http.req.version "\"HTTPS/1.1\"" > add rewrite policy RW_POL true RW_ACT

C. >add rewrite action RW_ACT replace http.res.version "\"HTTPS/1.1\"" > add rewrite policy RW_POL true RW_ACT

D. >add rewrite action RW_ACT replace http.req.version "\"HTTPS/1.0\"" > add rewrite policy RW_POL true RW_ACT