Referring to the exhibit, not all routes are being exchanged by EBGP peers.

In this scenario, which BGP parameter would solve this problem?

A. multihop

B. multipath

C. multipath multiple-as

D. as-override

You are designing a Layer 3 fabric underlay using EBGP. You will implement an EVPN-signaled VXLAN overlay on the Layer 3 fabric.

In this scenario, what must you do in the underlay to ensure that the VXLAN overlay will be able to function properly?

A. The underlay should advertise the host-connected interfaces on all leaf devices.

B. Each device in the underlay should advertise its loopback address.

C. The underlay should be configured with a separate VRF for each potential tenant.

D. The underlay should support the PIM protocol.

When using EBGP as the underlay protocol for your IP fabric architecture, which two statements are true? (Choose two.)

A. Spine nodes only peer to leaf nodes.

B. Leaf nodes peer to both spine and leaf nodes.

C. Leaf nodes only peer to spine nodes.

D. Spine nodes peer to both leaf and spine nodes.

Your colleague has begun working on the base configuration for an active-active multihomed EVPN connection shown in the exhibit.

Which two actions will ensure a successful implementation? (Choose two.)

A. Change the ESI mode on PE1 to single-active.

B. Change the ESI mode on PE2 to all-active.

C. Change the ESI value on the PE2 device to 00:00:00:00:00:00:00:00:00:00.

D. Change the ESI value on the PE1 device to 00:22:44:66:88:00:22:44:66:88.

You are asked to configure VXLAN for your data center using multicast to exchange VTEP information.

In this scenario, which two configuration parameters must match on the VTEPs in the same VXLAN segment? (Choose two.)

A. multicast group

B. VLAN ID

C. routing instance name

D. VNI