Your company is designing a new data center in a remote location that must be connected to your local data center. You have a service provider connection between the CE devices at each site. You want to implement EVPN with VXLAN services between sites, but the service provider does not offer EVPN services. Which two statements are true in this scenario? (Choose two )

A. The provider's edge devices must map your VXLAN VNIs to MPLS LSPs within the provider network at each site

B. The customer's edge devices within your data center can act as VXLAN Layer 2 gateways

C. You can still implement EVPN service across the service provider as long as there is IP reachability between the sites.

D. The service provider must provide an MPLS-based VPN connection between sites

Your customer wants an MPLS-based L3VPN service between multiple remote locations. Which two statements are true regarding the customer's WAN edge devices? (Choose two )

A. They must have EBGP configured.

B. They require routes for all remote sites.

C. They must have MPLS configured.

D. They require IP connectivity with the PEs.

Your customer is deploying a data center with redundant connections for WAN services through ISP-1 and ISP-2. Your customer has decided to deploy an active/passive Internet connection uplink model and pay-per-use for a passive connection associated with ISP-2. The customer wants to ensure limited use of the connection through ISP-2. Which two actions would you perform to meet the objective? (Choose two )

A. Extend the AS Path length on the prefix advertised to ISP-1 to influence ingress traffic to enter through ISP-1.

B. Use MED and Origin to direct northbound traffic flows out ISP-1

C. Extend the AS Path length on the prefix advertised to ISP-2 to influence ingress traffic to enter through ISP-1.

D. Use Local Preference to direct northbound traffic flows out ISP-1

Exhibit: Within ISP E, R1 is load-balancing traffic destined to ISP D over the R1-R2-R5 and R1-R4-R5 paths. At some point, a link degradation event occurs in the network as shown in the exhibit. You want R1 to rapidly learn of the path failure.

A. Adjust the OSPF hello timer to a subsecond value between R1 and R4.

B. Enable Bidirectional Forwarding Detection between R1 and R4.

C. Enable Bidirectional Forwarding Detection between R4 and R5.

D. Adjust the OSPF hello timer to a subsecond value between R4 and R5.

Your customer requires redundant routers and wants to use VRRP for the default gateway at their Internet edge. Which two statements are correct in this scenario? (Choose two )

A. VRRP will only support two routers

B. The VRRP master and backup send advertisements to each other at regular intervals.

C. VRRP dynamically elects master and backup routers

D. VRRP for IPv6 provides a much faster switchover to an alternate default router than IPv6 neighbor discovery procedures