Two direct connected routers are running RIPv2, neighbors are up but there is no route in the RIP database. Review the configuration information below. What is the potential problem?

A. System interface is not added to the RIP protocol

B. No import policy is configured

C. No export policy is configured

D. Split-horizon has to be disabled in RIP

E. Message-size has to be configured with a non-zero value

Node A has an active BGP route 10.1.1.1 in its routing table, but the same route is not found in Node D routing table. Which of the following configurations are required to resolve this problem?

A. Add Interface X to OSPF on Node B as passive interface

B. Redistribute interface address Y and Z into BGP

C. ISIS Enable route-reflection on Node B

D. Enable next-hop-self on Node C

E. Enable route-reflection on Node C

What MPLS tunnel label(s) will be used in the data packet traveling on LSP toR4 FRR leaving from Node 3 to Node 4?

A. 131069 131068

B. 131068 3

C. 131069

D. 131068

E. No label is used in the data packet

Node 1 and Node 2 are directly connected running LDP. The system ip address of Node 2 is 10.10.10.1.2. Based on the following display, why is the sdp down?

A. Local SDP id does not match with the remote sdp id.

B. Far End IP address is not reachable.

C. Keepalive has to be enable on the SDP.

D. LDP is not enable on the remote node's interface.

E. Targeted LDP session is disabled on the remote node.

An operator has entered the following CLI commands to configured redistribution of OSPF routes into ISIS. None of the active OSPF routes are redistributed into ISIS, what is the problem in the CLI commands?

A. OSPF area has to be configured as NSSA

B. Default-action has to be configured as accept

C. Import policy has to be configured under OSPF

D. The policy is still in edit mode, therefore it will not take any effect

E. to protocol isis has to be added under entry 10