An LTM device pool has suddenly been marked down by a monitor. The pool consists of members 10.0.1.1:443 and 10.0.1.2:443 and are verified to be listening. The affected virtual server is 10.0.0.1:80.

Which two tools should the LTM Specialist use to troubleshoot the associated HTTPS pool monitor via the command line interface? (Choose two.)

A. curl

B. telnet

C. ssldump

D. tcpdump

An LTM Specialist is troubleshooting virtual server 10.0.0.1:443 residing on VLAN vlan301. The web application is accessed via www.example.com. The LTM Specialist wants to save a packet capture with complete decrypted payload for external analysis.

Which command should the LTM Specialist execute on the LTM device command line interface?

A. tcpdump -vvv -s 0 'host 10.0.0.1 and port 443' -w /var/tmp/trace.cap

B. tcpdump -vvv -s 0 -ni vlan301 'host 10.0.0.1 and port 443' -w /var/tmp/trace.cap

C. ssldump -Aed -k /config/filestore/files_d/Common_d/certificate_key_d/:Common:www.example.com.key_1 > /var/tmp/trace.cap

D. ssldump -Aed -ni vlan301 -k /config/filestore/files_d/Common_d/certificate_key_d/:Common:www.example.com.key_1 > /var/tmp/trace.cap

What do the following iRule commands do when they are used in the same iRule?

set hsl [HSL::open -proto UDP -pool syslog_server_pool]

HSL::send $hsl "<190> [HTTP::host] from [whereis [IP::client_addr] country continent state city zip] , IP: [IP::client_addr]"

A. The commands set up a high-speed logging connection and then send the geographical database to the server.

B. The commands set up a high-speed logging connection and then send the host header and client geographical detail to the connection.

C. The commands set up a high-speed logging connection and then send the host header, HTTP payload, and client geographical detail to the connection.

D. The commands set up a high-speed logging connection to the LTM device and then send the host header and client geographical detail to the connection.

Which command will identify the active LTM device currently handling client traffic?

A. b ha table show

B. tmsh list /sys ha-status

C. tmsh show /cm traffic-group

D. tmsh run /sys failover standby

E. tmsh show /sys ha-status all-properties

An LTM Specialist connects to an LTM device via the serial console cable and receives unreadable output. The LTM Specialist is using the appropriate cable and connecting it to the correct serial port. Which command should the LTM Specialist run through ssh to verify that the baud rate settings for the serial port are correct on the LTM device?

A. tmsh list /sys console

B. tmsh edit /sys console

C. tmsh show /sys console

D. tmsh show /ltm console