An end user is experiencing network latency when accessing a database in a disaster recovery site. The monitoring team concluded that the database was writing simultaneously to the storage arrays on the primary and disaster recovery sites.

Which design resolves this issue?

A. asynchronous replication between data centers

B. synchronous replication between data centers

C. FCoE tunnel between data center

D. FCIP tunneling between data center

A database administrator experiences delay when performing storage replication between primary and secondary data centers. The data centers are located 20 kilometers apart and are connected using a 500 Mbps link. The deployment was implemented using an FCIP tunnel and a pair of Cisco MDS 9250 Series Switches. The network engineer decided to enable QoS to prioritize replication traffic.

Which QoS model must be used to resolve the performance issues?

A. Resource Reservation Protocol

B. weighted round robin

C. differentiated services

D. strict priority queuing

An engineer must build a VXLAN flood-and-learned network. The customer requires the solution to be based on the IETF documented practice in RFC 7348. The solution must use broadcast, unknown unicast, and multicast (BUM) and include the efficient BUM and short BUM replication modes that use only shared trees.

Which technology meets these requirements?

A. MVPN

B. Bidirectional PIM

C. PIM SSM

D. PIM sparse mode

Refer to the exhibit.

A Cisco engineer is configuring a customer scenario with 2 x MDS 9000 switches 24 x UCS B200M6 blade servers. UCS 64S4 Fabric Interconnect in end-host mode and 3 x UCS 5108 server chassis with 2408 Fabric Extenders The engineer installs 6 x SQL Server 2019 on all blades and then notices that there are read and write latencies

What is the best way to balance the utilization across the shared ports?

A. Enable "Only dedicate rate mode

B. Change the assigned speed to 8 Gbps Auto.

C. Set 4 Gbps performance buffers

D. Disable restrictions on oversubscription ratios

A network architect proposes a distinct Fibre Channel fabric to be used for a Cisco UCS blade server that hosts critical applications.

Which action should be implemented for the fibre Channel traffic from the vHBA of this service to pass through the I/O module in the Cisco chassis to a specified uplink Fibre Channel port?

A. Include a SAN pin group in the vHBA policy.

B. Update the applled Fibre Channel adapter policy.

C. Update the applled global QoS policy.

D. Enable persistent binding in the vHBA policy.